Ultraslide Sliding Door HD

The automatic door shall be an ULTRASLIDE automatic door operator designed and manufactured in New Zealand by SELF OPENING DOORS LTD. The operator is to be compliant with NZS/AS 4085, standard for automatic door operators, be EMC compliant and conform to the requirements of the New Zealand building code. The operator is to utilize state of the art electronics to provide unmatched functionality and ease of installation.

MECHANICAL

The operator shall be driven via a toothed timing belt from a 40 volt DC permanent magnet, variable speed, continuously rated motor. The driven system shall be Nylon 66 wheels with encapsulated bearings on a hard anodised aluminium track ensuring a smooth, quiet operation. Adjustable anti-rise wheels shall prevent the doors from de-railing. The operator shall be supplied in an extruded aluminium cowl 215mm high x 170mm deep.

LOCKING

Locking shall be by way of an electric motor lock, factory fitted to the drive shaft of the motor. This ensures no alignment problems associate with mechanical type locks.

CONTROLS

The door functions shall be controlled by a five position membrane switch. The following modes shall be selectable:

Auto: For normal use. The door operates in a fully automatic mode for two-way traffic.

Half Open/Three Quarter Open
For adverse climate conditions, door operates as in auto mode but only opens halfway.
Open: The door will remain fully open.
Lock: The door closes and the motor lock engages. It ignores all inputs except emergency exit, security and fire open signals.
Exit: The door closes and the motor lock engages. The door will open for traffic leaving the building only.

ACTIVATION

By Eagle 6 Microwave sensors, one on either side of the door.
By dual safety light cells fitted at 100mm and 600mm above finished floor level.
By backlit emergency egress button.

FUNCTIONS

All of the following functions shall be independently adjustable:

Opening speed
Closing speed
Dwell time
Braking force

FAILSAFE AND BATTERY

To be a fully monitored UPS system monitoring both battery and door operation. In case of power failure in auto mode the battery shall continue to provide full operation of the door for 200 complete open and close cycles. When the battery is too low to run the operator the doors will failsafe open. In case if power failure in lock mode the battery shall retain full locking for 8 hours.

SECURITY INTERFACE SPECIFICATION

The operator can be fitted with an Ultra-ID Security IO Panel. This interface will allow easy integration with any building management systems. Wiring to building management system by others.

The interface shall have clean contact relay outputs for the following functions. These outputs are selectable by jumper to be either normally open or normally closed. Activation of the relay is accompanies by an LED indication for easy fault diagnosis.

Door Closed
Safety light cells blocked
Door Locked
Door in hold open mode
Door in lock mode
Door in auto mode
Door forced
Mains in power failure
Door in controlled mode
Battery low

The interface shall have inputs for the following control functions:

TECHNICAL DETAILS

Power Supply

Motor

Power Consumption

Operation

Drive System

Maximum Weight
Door Leaf

Maximum Opening
Speed Per Leaf

230 Volt AC 50/60Hz

40 Vol DC Permanent Magnet

300 watts max

Continuous Rated

Toothed Timing Belt

Single 210 kg
Bi-parting 135kg each

Single 700mm/sec
Bi-parting 1400mm/sec

Maximum Closing force limited to

Minimum Operator Length

Maximum Operator Length

Hold Open Time

Failsafe

Early Morning Entry Feature

Battery Level Indicator

130N

Single 1700mm
Bi-parting 2100mm

Single 5000mm
Bi-parting 6000mm

0-60 seconds

Standard